R-0331 R-panel filler, IML, Transverse
The R-0331 filler runs horizontally across the R-panel siding on the interior side for those panels with ridges that run vertically. Standard widths are the same as standard lumber (3.5 inch and 5.5 inch).
NOTE: This item is normally sold to professional installers. If you need both horizontal and vertical pieces to frame a rough-in cutout inside your metal building, consider our Haslet One-Piece Frame or our Haslet Frame Kits.
The R-0331 filler runs horizontally across the R-panel siding on the interior side for those panels with ridges that run vertically. Standard widths are the same as standard lumber (3.5 inch and 5.5 inch).
NOTE: This item is normally sold to professional installers. If you need both horizontal and vertical pieces to frame a rough-in cutout inside your metal building, consider our Haslet One-Piece Frame or our Haslet Frame Kits.
The R-0331 filler runs horizontally across the R-panel siding on the interior side for those panels with ridges that run vertically. Standard widths are the same as standard lumber (3.5 inch and 5.5 inch).
NOTE: This item is normally sold to professional installers. If you need both horizontal and vertical pieces to frame a rough-in cutout inside your metal building, consider our Haslet One-Piece Frame or our Haslet Frame Kits.
NOTE ON LENGTH:
Any length up to 10 ft can be ordered; however, keep in mind that positioning the horizontal pieces is dictated by the ridges on the building's siding. Unlike flat faying surfaces, there are no minor adjustments due to the "locked-in" position of the siding ridges.
Be sure to order ample length per the formula below such that any reposition takes into account the full 12 inch segment shift due to the distance between the ridges.
L (to order) = Length (required) + 12 inches
EXAMPLE:
Framing an exhaust fan cutout, the rough-in cutout is 30" wide. A frame will be installed around the cutout . Each side of the frame will be 5.5" wide. The total length of the horizontal pieces (see the top and bottom items in blue in the figure) will be 30 + 2 x 5.5 = 41 inch.
Because the rough-in cutout could fall anywhere in the panel ridge patter, the recommended length to order for the horizontal pieces is:
L (order) = 41 + 12 = 56 inches
Best is to send us your rough-in cutout dimensions. Feel free to email us or call for any questions: 817-939-5671
